Print Friendly and PDF

DIY toy box for messy kids!

This versatile toy box is fun to make and fun to use. We show you how to make two different toy boxes - using stain or paint.

This easy toy box will help to bring back a bit of order to your home. You can build the toy box with pine plywood and stain, or you can build with SupaWood and apply a custom paint finish.

2 of 600 x 460mm 16mm plywood/supawood - front/back

1 of 400 x 600mm 16mm plywood/supawood - base

2 of 368 x 460mm 16mm plywood/supawood - sides

1 of 366 x 566mm 16mm plywood/supawood - lid

1 of 20 x 20mm x 568mm furring strip - lid support

Pattex No More Nails adhesive and caulking gun

Medium panel pins (if not using pneumatic nail gun)

Woodoc 5 or 10 interior sealer, tinted

Craft paint for lettering

Letter stencils

Masking tape

Paintbrush

Handles [3] and screws

Castors [4] and 16mm screws

TOOLS:

Drill / Driver plus assorted bits

Hammer - if not using pneumatic nailer

Tape measure and pencil

Buy all the tools and supplies for this project at your local Builders.

 

1. Lay out your pieces to help position them correctly when assembling the box.

2. Use adhesive and panel pins to secure the sides, front and back on top of the base - see below.

3. Measure down 16mm on the front and back and mark. This will be for mounting the furring strip - lid support.

4. Glue the furring strips in place and drive in 3 or 4 panel pins (or use a pneumatic nailer).

5. Apply wood sealer to the entire box, inside and out. Following the manufacturer's instructions for proper application.

6. Measure and mark the centre on the front.

7. Let the sealer dry for the recommended time before taping down the stencils with masking tape. Use the centre guide as a mark for positioning the letter stencils.

8. Dip your brush lightly into the paint and dot over the stencil. To create a spray painted look, you’ll want to blend the paint leaving areas with less colour.

9. Let the paint dry and then remove the tape and stencils. Flip the box over and repeat for the opposite side, if desired.

10. Position a caster inside each corner of the base and secure with 16mm screws.

11. Measure equally from side to side where you’d like the handles to be and secure the handle to the sides and lid.

 

back to top